Dialogo semplice — da PDP-10 a 940

Un utente a Utah è seduto davanti a una telescrivente collegata ai due PDP-10 dell'Università. Desidera usare il sottosistema CAL sul 940 presso SRI a Menlo Park, California.

   .LOGIN<CR>                          PDP-10 login
    ---------

   .R TELNET<CR>                       The PDP-10 run command
    ------------                       is issued to call and start
                                       the TELNET subsystem.
   *ESCAPE CHARACTER IS #<CR>          The user indicates an escape
    -------------------------          character which TELNET
                                       will watch for in subsequent
                                       input from the user.

   *CONNECT TO SRI<CR>                 The TELNET subsystem will make
    ------------------                 the appropriate system call
                                       (UUO) to establish a primary
                                       connection.  The connection
                                       will be established, provided:
                                       1.  SRI is willing to accept
                                       another foreign user;
                                       2.  The UTAH user is cleared
                                       for network access at UTAH.
                                       This is determined by a
                                       status word kept in the PDP-10

                                       monitor for each user.

   @LOGIN CARR.                        The user logs in SRI.
    --    -----

I caratteri digitati sulla telescrivente dell'utente vengono trasmessi inalterati attraverso il PDP-10 (host dell'utente) e fino al 940 (host servente). (Fa eccezione una possibile conversione di codice uno-a-uno richiesta, per esempio, tra il Sigma 7 della UCLA e il PDP-10).

   @CAL.                               The PDP-10 TELNET subsystem
    -  -                               switches to full duplex,
                                       character-by-character
                                       transmission, since this is
                                       required by 940's.  Characters
                                       typed by the user are
                                       underlined. Full duplex
                                       operation is allowed for by
                                       the PDP-10, though not used
                                       by most DEC subsystems.

L'utente desidera caricare un file CAL nel CAL del 940 dal file system del suo PDP-10 locale.

   CAL AT YOUR SERVICE
   >READ FILE FROM NETWRK.             'NETWRK' is a predefined
    ----------------------             940 name similar to PAPER
                                       TAPE OR TELETYPE.  The 940
                                       file opening BRS is set to
                                       expect an auxiliary connection
                                       and the file from UTAH.

   #NETWRK: <- DSK:MYFILE.CAL<CR>      The user types the prescribed
    -----------------------------      escape character, followed by
                                       the TELNET command, to send
                                       the desired file to SRI on an
                                       auxiliary connection.  The
                                       user's next statement is in
                                       CAL again.