RFC 4862 - IPv6 Stateless Address Autoconfiguration

• Status: Draft Standard
• Published: September 2007
• Stream: IETF
• Obsoletes: RFC2462
• Errata: No Errata

---

Abstract

This document specifies the steps a host takes in deciding how to autoconfigure its interfaces in IP version 6. The autoconfiguration process includes generating a link-local address, generating global addresses via stateless address autoconfiguration, and the Duplicate Address Detection procedure to verify the uniqueness of the addresses on a link.

---

Contents

• 1. Introduction
• 2. Terminology
  • 2.1 Requirements
• 3. Design Goals
• 4. Protocol Overview
  • 4.1 Site Renumbering
• 5. Protocol Specification
  • 5.1 Node Configuration Variables
  • 5.2 Autoconfiguration-Related Structures
  • 5.3 Creation of Link-Local Addresses
  • 5.4 Duplicate Address Detection
  • 5.5 Creation of Global Addresses
  • 5.6 Configuration Consistency
  • 5.7 Retaining Configured Addresses for Stability
• 6. Security Considerations
• 7. Acknowledgements
• 8. References
  • 8.1 Normative References
  • 8.2 Informative References

Appendices

• Appendix A. Loopback Suppression and Duplicate Address Detection
• Appendix B. Changes since RFC 1971
• Appendix C. Changes since RFC 2462

---

Related Resources

• Official Text: ````https://www.rfc-editor.org/rfc/rfc4862.txt\````
• Official Page: ````https://datatracker.ietf.org/doc/html/rfc4862\````
• Errata: ````https://www.rfc-editor.org/errata_search.php?rfc=4862\````

---