1. Introduction
"Multi-Protocol Label Switching (MPLS)" [1] requires a set of
procedures for augmenting network layer packets with "label stacks",
thereby turning them into "labeled packets". Routers which support
MPLS are known as "Label Switching Routers", or "LSRs". In order to
transmit a labeled packet on a particular data link, an LSR must
support an encoding technique which, given a label stack and a
network layer packet, produces a labeled packet.
This document specifies the encoding to be used by an LSR in order to
transmit labeled packets on PPP data links and on LAN data links.
The specified encoding may also be useful for other data links as
well.
This document also specifies rules and procedures for processing the
various fields of the label stack encoding. Since MPLS is
independent of any particular network layer protocol, the majority of
such procedures are also protocol-independent. A few, however, do
differ for different protocols. In this document, we specify the
protocol-independent procedures, and we specify the protocol-
dependent procedures for IPv4 and IPv6.
LSRs that are implemented on certain switching devices (such as ATM
switches) may use different encoding techniques for encoding the top
one or two entries of the label stack. When the label stack has
additional entries, however, the encoding technique described in this
document MUST be used for the additional label stack entries.
1.1. Specification of Requirements
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this